Transmitter mode :HIGH mode (See p.42 for setting method.) Under other conditions, the set will not operate, or the specified performance will not be displayed even if it operates. In addition, it may cause servo trouble. Futaba will not be responsible for damage, etc. caused by combination with the products of other companies.
8. Test your switch setting by cycling through the three positions for the G switch (up, center, down). If set correctly, the ON/OFF setting should change from “OFF” for the up position to “ON” for the mid and down positions. “ON” simply means that the transmitter enables elevator mix-in for the mid and down positions
Everything is in the manual. For flaperons, you can either do snap flaps, or separate flap control, or both. You can set up preset up or down flaps on a 2- or 3-way switch, or have full variable control on a control such as a stick or slider. You can also set up a flap preset based on a condition. Each of your two aileron servos must be plugged
In this amateur "how-to" RC sailing video, we explain how to set up a radio system Futaba T6K with a receiver which is in a hull connected with electronics.
MIX 3. Airbrake Channel (master) -> Rudder Servo #1 (slave) You can choose which channel you wish to use for airbrakes. The easiest is probably the retract switch, but you may prefer a flap knob or some other switch on the transmitter that is not being used. MIX 4. Airbrake Channel (master) -> Rudder Servo #2 (slave) Same as above.
All you have to do is designate a second channel in the function menu to elevator. All trims and other elevator functions will follow to the second channel and there is no need for further programming or reprogramming other than setting up subtrim and end points on the new channel. Reply Like. 06-06-2018, 08:32 AM. # 11.
UPo6HF. 26 16 268 392 281 359 122 362 120
how to set up futaba transmitter
